Technology of laying gypsum tiles along with your own hands

Gypsum tiles have to be laid correctly, as not just the aesthetic appearance of cosmetic facing, but in addition the service life

of this substance will depend on the technologies of work. The product is more universal, and it can be connected to concrete,

plaster, brick or gypsum board sheets, and provided the surface of the base is and has no flaws.

In the event the defects of this base are important, it ought to be completely treated with primer, then a cement mortar is made,

which fills all the cracks. Subsequently the surface should be primed and dried. In this case, its composition should decide on a

particular, containing components which block the look of fungus and mold.

In the modern interior of these rooms most often used gypsum tiles, even imitating natural brick or stone. To execute decorative

finishing your self, it is necessary first of all to choose a strategy of tile placement and prepare a remedy. It is necessary to

pay attention to the opposite side of this material. When its surface includes an embossed surface, then the glue ought to be put

using an trowel, and if it’s even, then with a top notch one.

The tech of the work is as follows:

* A thin layer of glue is put on the pre-prepared wall. It’s spread over the base so it is likely to place 4-5 tiles. Decorative

cladding can be put either on plasterboard, also on putty.

* Glue the rear side of these tiles with adhesive.

* Plaster elements are pushed against the walls and their location is adjusted. To align the seams, it is recommended to use


* Finishing is carried out in rows, all which ought to be shifted by half a tile. Facing is carried out into the corners of this

space, then immediately eliminate any residual mortar in the joints.

Drying the walls requires no more than a day and requires a constant humidity and temperature inside the room. The last point in

the placing of gypsum tiles is that their decoration. To get this done, the joints between these components are filled with a

particular solution, the color of which matches the brick.

Decorative imitation of brickwork on the walls has been carried out in the following ways:

* Cutting on the darkened surface of the seams of masonry with a bolt cutter with your hands;

* laying of tiles under the brick:

* imitating the structure and colour of the side surface of one brick;

* Imitating a fragment of brickwork of several bricks.

The best approach to decorate”under the brick” is really the one which permits you to make a practical coating together with the

most look of its similarity to natural masonry. All 3 methods to execute this sort of finishing works fulfill the needs, however,

the cutting edge of joints with a bolt will be labor-intensive and also the creation of large quantities of dust, so let’s

consider more typical ways.

The old finish is removed from the walls, and also the outside, if necessary, is leveled to eliminate the requirement to paste

plaster on a thick coating of glue.

Combining these cladding with other types of interior finishes may be both orderly and performed without any clear consequences,

chaotically, together with imitation of signs of aging.

With the help of decorative gypsum tiles it’s possible to imitate a large number of textures.

A large number of textures could be imitated with the support of decorative gypsum tiles.

The wall on which it’s to be installed should possess the following attributes:

* Hardness and intensity of the outside;

* The lack of irregular locations and sharp sections;

* no more deformations.

Decorative tiles in the interior of the kitchen

Walls are created from a number of materials, let’s break down the individual rules of setup.

When dealing with concrete, there will be no huge problems. It’s simply essential to take into consideration the porosity of this

material. Concrete, which has virtually no pronounced pores, should be treated with a fantastic primer.

Mounting gypsum tiles concrete

Before beginning work on the setup of gypsum tiles to the walls, it’s worth checking the strength of this surface. After the

plaster does not drop off the wall and at precisely the identical time holds well, it is possible to simply paint it using primer.

Mount the tiles on the painted concrete should not. The surface ought to be scratched, making sure to misfire, and it needs to be

grouted and coated with a layer of plaster.

Leave a comment